Rear Wheel Hub Assembly and Bearing FIT for 2012-2017 Toyota Camry, FIT for 2013-2018 Avalon, 5-Lug with ABS Sensor, Replace 512454 42460-06070 (Driver Side)

Core Technical Specs: OE Part Number: 512454, 42460-06070, 42460-06100, 42460-33010 Position: Rear Left (Driver Side) Only Wheel Studs: 5-Lug Pattern ABS System: Integrated 4-Pin Sensor & Harness Material: Induction-Hardened GCr15 Steel Vehicle Compatibility Matrix (Rear Only): 2012-2017 FIT for Toyota Camry (All Trims) 2013-2018 FIT for Toyota Avalon (All Trims) Note: This part is specifically for the Driver Side. For the Passenger Side, please order 512455. Anti-Refuns Technical Notice: To prevent premature bearing noise or ABS fault codes, ensure the mounting surface on the steering knuckle is polished clean before seating the 4-bolt flange. Improper torque on the axle nut is the leading cause of early bearing failure; refer to your service manual for exact torque-to-yield values. Mechanical Restoration: Ideal for replacing original rear hub units exhibiting rhythmic humming or vibrations. By installing this precision-machined 512454 unit, you restore the critical wheel-to-suspension connection, ensuring safe and quiet operation for your Toyota sedan.

• FIT for 2012 2013 2014 2015 2016 2017 Toyota Camry and 2013-2018 Toyota Avalon. This rear wheel hub assembly is a direct replacement for OE part numbers 512454, 42460-06070, and 42460-06100. Position: Rear Left (Driver Side). Please verify your vehicle's side requirement before purchase to ensure a precise physical match.
• Constructed from induction-hardened GCr15 high-carbon steel with precision-ground internal raceways to withstand radial and axial loads. This 5-lug rear hub features an OE-style mounting flange and pre-installed wheel studs. The sealed housing design utilizes multi-lip seals to prevent moisture and road debris from contaminating the internal ball bearings.
• Features an integrated ABS speed sensor with a factory-standard 4-pin connector to restore accurate wheel speed data transmission. This rear wheel bearing unit is designed to eliminate common symptoms such as "Growling" or "Grinding" noises that increase with vehicle speed. Every unit is tested for rotational balance and sensor signal integrity prior to shipment.
• Designed for a direct-fit bolt-on installation, restoring factory-level steering stability and rear suspension alignment. The precision-machined hub pilot ensures centralized wheel mounting, preventing uneven tire wear and high-speed chassis vibrations. This 512454 model maintains OE tolerances for flange runout to ensure quiet operation.
• Installation Notice: Axle nut must be torqued to factory specifications to maintain proper bearing preload; do not use an impact wrench for final seating of the assembly. Strict Exclusion: This unit is side-specific; 512454 fits the Left/Driver side only. Ensure the mounting surface on the knuckle is clear of rust and debris before installation.