1PCS 220V 350W Motor Permanent Magnet Double Ball Bearing High-Speed Lathe Drill Grinding Table Drill Motor(Type D)

Generators220V 350W Motor Permanent Magnet Double Ball Bearing High-speed Lathe Drill Grinding Table Drill MotorNOTE !1.The motor needs to be connected to the provided rectifier bridge in order to use 220V AC power. Remember to use 220V AC power directly, and you will be responsible for burning it out! If you buy a set with a speed controller, simply connect the motor directly to the speed controller without the need for a rectifier bridge; The motor speed is about 7000 rpm without load, with an error of 5-8%. The speed range is between 700 rpm and 7000 rpm. After lowering it, the force decreases. If the load is too large, the motor or speed controller will burn out. Therefore, it is recommended to slightly adjust the speed controller. The motor can rotate forward or reverse, and is a carbon brush motor.2.This 350W motor does not have heat dissipation and cannot be operated for a long time (controlled within 30-40 minutes according to load size)! Continuous high temperatures will burn out the motor!3.The B12 chuck (which can hold drill bits within the range of 1.5-10 millimeters) is a three seater, with a error of 25 threads. Buyers with high requirements should directly purchase the ER clamp (because there is a tolerance between the ER clamp and the motor shaft, there may be a possibility of not being able to fit it in, so the motor needs to be turned and sanded a few times, but do not smash the motor shaft as it may damage the motor);4.The set in this connection cannot be compared to the bench drill with a reduction gear on the market because it has not been decelerated by a wheel.5.If you want to drill large holes or drill metal holes, you need to use an unpowered for modification; It cannot be used directly, and burning it is not responsible.6.Please be sure to pay attention. If you want to drill metal or use a thicker drill bit, please modify it with an unpowered .Type A: Motor * 1pc andclamp+connecting rod * 1pc andspeed regulator * 1pc and bracket * 1pcType B: Motor * 1pc andclamp+connecting rod * 1pc andspeed regulator * 1pcType C: Motor * 1pc andspeed regulator * 1pc and bracket * 1pcType D: Motor * 1pc andspeed regulator * 1pcType E: Motor * 1pc andclamp+connecting rod * 1pc and bracket * 1pc and rectifier bridge*1pcType F: Motor * 1pc andclamp+connecting rod * 1pc and rectifier bridge*1pcType G: Motor * 1pc and bracket * 1pc and rectifier bridge*1pc==========Hign-concerned Chemical : NoneConstruction : Permanent MagnetProtect Feature : Totally EnclosedOutput Power : 350W

• Generators
• 1PCS 220V 350W Motor Permanent Magnet Double Ball Bearing High-speed Lathe Drill Grinding Table Drill Motor