Magnate 9496 2 Flute Spiral Down-Cut Router Bit - 7/16" Cutting Diameter, 1-3/4" Cutting Length

This 2-flute spiral bit is designed for solid wood and wood composites. While it can be used for certain plastic applications, O-flute and Z-flute bits are recommended. While this bit can cut Type I high-density foam, the up-cut bit is recommended over the down-cut one. A down-cut spiral bit is used where a downward chip removal and a good finish on top are required. A down-cut spiral bit provides downward pressure on the material and leaves an excellent finish on the top. Always refer to the operation manual of your router first, in the event that a router bit doesn't come with a speed chart, you may start at about 2,000 rpm slower than the maximum speed described in the chart below. Maximum speed below is for reference only, actual best performance speed varies depending on a number of factors i.e. size of the router bit, the material to be cut, etc. Run 24,000 rpm maximum for 1" overall diameter router bits; Run 20,000 rpm maximum for 1-1/2" overall diameter router bits; Run 18,000 rpm maximum for 2" overall diameter; Run 16,000 rpm maximum for 2-1/2" overall diameter router bits; Run 12,000 rpm maximum for 3" overall diameter router bits; Run 10,000 rpm maximum for 3-1/2" overall diameter router bits;

• Fish Tail End, Solid Carbide, Right-Hand; 1/2" Shank Diameter; 4" Overall Length