TK-WR110 (L:3FT & 6FT ID: 0.75"& 1"& 1.25") Aluminum Metallic Heat Shield Thermal Sleeve Insulated Wire Hose Cover Heat Shroud (6M141)

Heat Shroud is made from a high temperature rated glass fiber fabric with an aluminized outer facing. Same as Heat Sheath but with the added convenience of hook & loop closure design along the open edges. Without the need of removing one end of connected wires, cables and hoses, simply wrap Heat Shroud around whatever needs protection and close edges Convenient hook & loop designed edges Withstands 500°F direct continuous/2000°F radiant heat No need to remove wires and hoses Easily trimed to length We Have Different Size: WR110M34-3 ( (0.75"=3/4")diameters x 3 foot length) WR110M31 (1"diameters x 3 foot length) WR110M314-1 ((1.25"=1-1/4")diameters x 3 foot length) WR110M64-3 ((0.75"=3/4")diameters x 6 foot length) WR110M61 ( 1"diameters x 6 foot length) WR110M614-1 ((1.25"=1-1/4")diameters x 6 foot length) Fit: wiring, fuel lines, brake lines, intake tubes, pipes, spark plug wires, battery cables, A/C hoses, and more Rated for Moderate Heat: Not recommended for use on or against headers, exhaust pipes or extremely hot surfaces (The melting point of the Velcro fastener is about 325Fº) Can be used in about 90% of the underhood area when installed For best results seal the sleeves at each end with adhesive foil tape, shrink tube or stainless steel cable ties. Sleeves are conductive always insulate electric terminals that it might come in contact with sleeves. To ensure a proper fit, allow extra room for bends (for example: a 90º bend in a 3/4" tube will NOT fit in 3/4" I.D. Sleeve, In this case you would need 1" I.D. or higher) ** IMPORTANT INFORMATION** Minor modifications or adjustments maybe needed for some of our productsAll items are Brand New unless stated otherwise on the listingWe sell DIY (Do It Yourself) Items with a few exceptionsProfessional Installer Is Highly Recommend, No Installation Instruction Included