Phoenix Contact 4-Position Flush Connector, 0.5mm, 250V, 4A, IP67, M16 x 1.5

Caution: Avoid plugging in or disconnecting connectors under load. Improper use may cause damage. Ensure products are functioning properly and replace damaged ones immediately. Only qualified electrical personnel should install and operate the product, following safety guidelines. Suitable for plant, controller, and electrical device engineering. Protect connectors from environmental influences in outdoor applications. Do not manipulate or improperly open assembled products. Use specified mating connectors. User responsible for direct connection with third-party manufacturers. Ground conductive connector housings for operating voltages > 50 V AC. Limit tensile load on connectors during cable laying. Observe technical data found on product, packing label, documentation, or online. Use recommended tools and protective caps for unused connectors. Ensure proper ground connection. Follow VDE 0100/1.97 411.1.3.2 and DIN EN 60 204/11.98 14.1.3 for combining circuits. Post warnings for connector surface heat-up. Features 4 positions, 'A' coding, II overvoltage category, 2.5 kV AC rated surge voltage, 250 V nominal voltage, 4 A nominal current, cable connection, 1 m cable length, 0.5 mm cable cross-section, IP67 (when plugged in) degree of protection, -25C to 85C operating temperature range, according to IEC 61076-2-101 standards, rear mounting (M16 x 1.5). Packed 1 pc, minimum order 10 pc, weighs 74 g including/excluding packing, GTIN 4046356886819, origin DE. UNSPSC 21.0, 39121413. China RoHS EFUP-50, no China RoHS declaration table required. EU REACH SVHC, no substance above 0.1 wt%.